Lab Recordings - UE24EC1106
Experiment 10
Measurement of Current, Power and Power Factor of Incandescent Lamp, Fluorescent Lamp and LED Lamp.
Experiment 11
Two Way and Three-Way Control of Lamp and Formation of Truth Table.
Experiment 12
Determination of efficiency of a single-phase transformer by direct load test.
Experiment 1a
Design and set up the following rectifiers with and without filters and to determine ripple factor and rectifier efficiency: (a) half wave rectifier (b) Full Wave Rectifier.
Experiment 1b
Design and set up the following rectifiers with and without filters and to determine ripple factor and rectifier efficiency: (a) half wave rectifier (b) Full Wave Rectifier.
Experiment 2a
Conduct experiment to test diode clipping (single/double ended) and clamping circuits (positive/negative).
Experiment 2b
Conduct experiment to test diode clipping (single/double ended) and clamping circuits (positive/negative).
Experiment 3
Design and set-up the RC-Phase shift Oscillator using BJT, and calculate the frequency of output waveform.
Experiment 5a
Design Adder, Subtractor, Integrator and Differentiator using Op-Amp.
Experiment 5b
Design Adder, Subtractor, Integrator and Differentiator using Op-Amp.
Experiment 6
Construct an appropriate circuit employing an Op-Amp to replicate and indicate the Schmitt trigger for specific UTP and LTP values.
Experiment 8
Verify Demorgan’s Theorem for 2 variables.
Experiment 9
Verification of KCL and KVL for DC circuits.
